Safety Precautions - INVT DA180-S2R8SG0 Operation Manual

DA180 series basic AC servo drive
Safety symbols
Read this manual and follow the instructions.
Do not touch terminals within 15 minutes after power-on
or power-off. Otherwise, electric shock may result.
Do not touch the heat sink. Otherwise, burns may result.
The contact current can reach 0.5mA. Reliable grounding
must be complete before the use.
The safety symbols are marked in the front or side of the servo drive. Follow the safety instructions
when operating on the servo drive.
Recycling symbol
Check the following safety precautions before the installation, wiring, operation, maintenance,
or inspection:

Ensure that the AC power supply is consistent with the rated voltage of the drive. Otherwise,
drive damages, body injuries, or fire may result.

Do not connect an input power cable to an output terminal. Otherwise, drive damages may result.

Do not carry out any insulation and voltage withstand test to the drive directly, and do not test the
control circuit of the drive by megameter.

Connect the drive and motor in the correct phase sequence. Otherwise, drive faults or damages
may be caused.

To avoid accidents, disconnect the motor from the drive before trial operation, and then run the
motor independently.

Ensure that the drive can be disconnected from the power supply by the emergency switch
before mechanical running.

Set the corresponding parameters before operation. Otherwise, the drive may run abnormally or
unexpectedly due to load issues.

Only qualified electrical engineers can carry out the wiring. Otherwise, electric shock or fire may
result.

Safety precautions

When the life cycle ends, the product should enter the recycling system.
Dispose of it separately at an appropriate collection point instead of placing it
in the normal waste stream.
-II-
Safety precautions