Monitoring Mode; Parameter Setting Mode - INVT DA180-S2R8SG0 Operation Manual

DA180 series basic AC servo drive

5.2.3 Monitoring mode

You can press MODE to switch to the monitoring mode. Then you can press SHIFT to select group
codes for monitoring parameters circularly in one way, press UP/DOWN to select codes for
parameters in a group, or hold UP/DOWN for quick selection. After locating a target parameter, you
can press SET to check the current value and then press MODE to switch to the parameter code
display screen. If no operation is performed on an R3 menu screen in 20 seconds, the common
monitoring parameter screen is displayed. If no operation is performed on an R0 or R1 menu screen
in 20 seconds, the current parameter display screen is kept.
Operation flowchart
SHIFT
SHIFT
SHIFT

5.2.4 Parameter setting mode

You can press MODE to switch to the parameter setting mode. You can press SHIFT to select group
codes for parameters circularly in one way, press UP/DOWN to select codes for parameters in a
group, or hold UP/DOWN for quick selection. After locating a target parameter, you can press SET to
enter the current parameter value display screen and then press SHIFT to enter the parameter setting
screen where the parameter LSB blinks). After parameter setting, the LED displays
parameters are storable and P0.17 is set to 0) or
parameters or P0.17 is set to 1). The parameter mode is switched back automatically.
Operation flowchart
SHIFT
SHIFT
SHIFT
UP
DOWN
SET MODE
UP
DOWN
SET MODE
SHIFT
SHIFT
UP
DOWN
SET MODE
UP DOWN
UP DOWN
(if the parameters are non-storage
UP
DOWN
MODE
UP
DOWN
-69-
Operating and running
UP
DOWN
UP
DOWN
延时1秒
SET
(if the