Alarm Reporting - INVT DA180-S2R8SG0 Operation Manual

DA180 series basic AC servo drive
5.2.5.6 Absolute encoder clearing
If a multiturn absolute encoder is used, the homing operation for the mechanical system must be
performed after the first power-on. Then you can press MODE to enter the auxiliary function mode,
press UP/DOWN to enter the
clearing menu, which displays
clearing. The screen displays
. If the encoder type does not match or the clearing fails, the screen displays

5.2.6 Alarm reporting

If the servo drive runs abnormally, it reports a fault alarm and stops automatically, while the LED panel
displays the fault alarm symbol in the format of ErXX-X, in which XX is the main code and X is the sub
code.
For details, see section 10.4 "Fault codes".
SET MODE
SET MODE
延时3秒
menu, and press SET to enter the absolute encoder
. Then you can press SET to enable absolute encoder
. If the clearing is successful, the screen displays
SET MODE
MODE SET MODE
成功
-72-
延时2秒
MODE
失败
Operating and running
.