DA180 series basic AC servo drive
8.4.6 Program interface
The program interface consists of:
Menu bar and toolbar, entries to sub-interfaces and functions
Status monitoring area on the left, which displays the real-time feedback of status parameters
Parameter setting area on the right, used to modify parameters
Status bar, used to display the current communication mode and status, fault status, and user
permissions.
8.4.7 Setting parameters
To set a parameter, do as follows:
1. In the parameter setting area on the right, locate the row where the parameter resides.
2. Double click the value of the parameter. If you have the permission, enter or select a proper value
in the modification box.
3. Use either of the following methods to send the modification to the servo drive:
Press Enter in the editing window.
Click the sending button
8.4.8 Using the help manual
ServoPlorer is embedded with a .chm help manual, which provides software use instructions and
describes parameters. You can click the help button to obtain help information.
The main interface provides a general entry to the help manual, while the help button in each window
enables you to go to the mapping help information.
on the toolbar.
-256-
Communication