Configure The Attributes Of Aux (Console) Port - Huawei Quidway S5000 Series Operation Manual - Getting Started

Operation Manual - Getting Started
Quidway S5000 Series Ethernet Switches
Caution:
1) If Telnet protocol is specified, to ensure a successful login via the Telnet, you must configure the
password by default.
2) If SSH protocol is specified, to ensure a successful login, you must configure the local or remote
authentication of username and password using the authentication-mode scheme command. The
protocol inbound ssh configuration fails if you configure authentication-mode password and
authentication-mode none. When you configure SSH protocol successfully for the user interface, then
you cannot configure authentication-mode password and authentication-mode none any more.

4.2.3 Configure the Attributes of AUX (Console) Port

The following commands can be used for configuring the attributes of the AUX
(Console) port, including speed, flow control, parity, stop bit and data bit.
Perform the following configurations in user interface (AUX user interface only) view.
I. Configure the transmission speed on AUX (Console) port
Table 4-3 Configure the transmission speed on AUX (Console) port
Configure the transmission speed on AUX (Console) port
Restore the default transmission speed on AUX (Console) port
By default, the transmission speed on AUX (Console) port is 9600bps.
II. Configure the flow control on AUX (Console) port
Table 4-4 Configure the flow control on AUX (Console) port
Configure the flow control on AUX (Console) port
Restore the default flow control mode on AUX (Console) port
By default, the flow control on the AUX (Console) port is none, that is, no flow control
will be performed.
Operation
Operation
4-3
Chapter 4 User Interface Configuration
Command
speed speed-value
undo speed
Command
flow-control { hardware | none | software }
undo flow-control