Indexer Module Error Displays And Troubleshooting - YASKAWA E-7S SERVOPACK SGD7S Product Manual

15.3.3

INDEXER Module Error Displays and Troubleshooting

Negative responses (error responses) to input signals, serial commands, or operations from the
Digital Operator are known as errors.
The servo will not be turned OFF when an error occurs.
 Status Displays
SERVOPACK Panel Display
Indicator
Digital Operator
Response to the Alarm or Warning Read
Command (ALM)
Response to the Most Recent Error Read
Command (ERR)
ALM Signal
/WARN Signal
The INDEXER Module error displays and the corrective actions are shown below.
Serial
Command Alarm
Negative Number
Response
A.A9F
E41E
A.A9F
E42E
15.3.3 INDEXER Module Error Displays and Troubleshooting
"A.A9F" is displayed for 2 seconds.
Red indicator: Flashes for 2 seconds.
Refer to the following section for details.
"A.A9F" is displayed for 2 seconds at the top left of the
screen.
No change
Error code (the most recent (closest) error code)
No change
The signal is valid for 2 seconds.
Error Name
While writing data to the flash memory, a
failure occurred during one of the following
operation.
• While saving a program table by using a
PGMSTORE command
Program Table
• While saving a program table by using
Save Failure Error
FnB03
• While initializing a program table by using
a PGMINIT command
• While initializing a program table by using
FnB06
While writing data to the flash memory, a
failure occurred during one of the following
operation.
• While saving a ZONE table by using a
ZONESTORE command
ZONE Table Save
• While saving a ZONE table by using
Failure Error
FnB04
• While initializing a ZONE table by using a
ZONEINIT command
• While initializing a ZONE table by using
FnB07
1.5.2 Indicators on page 1-11
Meaning
15.3 Warning Displays
Corrective Action
Repair the hard-
ware.
Repair the hard-
ware.
Continued on next page.
15-61
15