Operation Of Digital Operator; Overview - YASKAWA E-7S SERVOPACK SGD7S Product Manual

17.2 Operation of Digital Operator

17.2.1 Overview

17.2 Operation of Digital Operator
17.2.1 Overview
Functions List
The table below shows whether functions of the digital operator can or cannot be used when
an INDEXER Module is installed.
This chapter describes the operating procedures for the functions indicated with the thick-bor-
dered frame in the table below. Refer to the following manual for information on functions that
are not marked with bold lines.
Σ-7-Series Servo Drive Digital Operator Operating Manual (Manual No.: SIEP S800001 33)
When an
INDEXER
Module is
installed
When no
INDEXER
Module is
installed
: Supported
−: Not supported
*
To copy the INDEXER Module parameters (PnB00 to PnB52), use the SigmaWin+ parameter editing function.
17-8
Parameters/Monitoring Functions
SERVOPACK
SERVOPACK
Monitor
Parameters
Display
Pn000 to Un000 to
Pn95F Un085
 
 
Utility Functions
INDEXER
SERVOPACK
Module
Utility Functions
Parameters
PnB00 to Fn000 to
PnB52 Fn207
 
−

Parameter Copy Functions
INDEXER
SERVOPACK
Module Utility
Parameters
Functions
FnB03 to Pn000 to
FnB0D Pn95F
 
−

INDEXER
Module
Parameters
PnB00 to
PnB52
−*
−