YASKAWA E-7S SERVOPACK SGD7S Product Manual page 520

Alarm
Alarm Name
Number
Polarity Detection
A.C50
Failure
Overtravel Detected
A.C51 during Polarity Detec-
tion
Polarity Detection Not
A.C52
Completed
Out of Range of
A.C53 Motion for Polarity
Detection
Polarity Detection
A.C54
Failure 2
Encoder Clear Error or
A.C80 Multiturn Limit Set-
ting Error
Encoder Communica-
A.C90
tions Error
Encoder Communica-
tions Position Data
A.C91
Acceleration Rate
Error
Encoder Communica-
A.C92
tions Timer Error
Encoder Parameter
A.CA0
Error
Encoder Echoback
A.Cb0
Error
Multiturn Limit Dis-
A.CC0
agreement
Reception Failed Error
in Feedback Option
A.CF1
Module Communica-
tions
Timer Stopped Error
in Feedback Option
A.CF2
Module Communica-
tions
Position Deviation
A.d00
Overflow
Position Deviation
A.d01 Overflow Alarm at
Servo ON
Position Deviation
Overflow Alarm for
A.d02
Speed Limit at Servo
ON
Alarm Meaning
The polarity detection failed.
The overtravel signal was detected during
polarity detection.
The servo was turned ON before the
polarity was detected.
The travel distance exceeded the setting
of Pn48E (Polarity Detection Range).
The polarity detection failed.
The multiturn data for the absolute
encoder was not correctly cleared or set.
Communications between the encoder
and SERVOPACK is not possible.
An error occurred in calculating the posi-
tion data of the encoder.
An error occurred in the communications
timer between the encoder and SERVO-
PACK.
The parameters in the encoder are cor-
rupted.
The contents of communications with the
encoder are incorrect.
Different multiturn limits have been set in
the encoder and the SERVOPACK.
Receiving data from the Feedback Option
Module failed.
An error occurred in the timer for commu-
nications with the Feedback Option Mod-
ule.
The setting of Pn520 (Excessive Position
Deviation Alarm Level) was exceeded by
the position deviation while the servo was
ON.
The servo was turned ON after the posi-
tion deviation exceeded the setting of
Pn526 (Excessive Position Deviation
Alarm Level at Servo ON) while the servo
was OFF.
If position deviation remains in the devia-
tion counter, the setting of Pn529 or
Pn584 (Speed Limit Level at Servo ON)
limits the speed when the servo is turned
ON. This alarm occurs if a position refer-
ence is input and the setting of Pn520
(Excessive Position Deviation Alarm Level)
is exceeded before the limit is cleared.
15.2 Alarm Displays
15.2.1 List of Alarms
Continued from previous page.
Servo- Alarm Code Output
Alarm
motor
Reset
Stop-
Possi-
/ALO1 /ALO2 /ALO3
ping
ble?
Method
Gr.1 No
Gr.1 Yes
Gr.1 Yes
Gr.1 No
Gr.1 No
Gr.1 No
Gr.1 No
L
Gr.1 No
Gr.1 No
Gr.1 No
Gr.1 No
Gr.1 No
Gr.1 No
Gr.1 No
Gr.1 Yes
Gr.1 Yes
L
Gr.2 Yes
Continued on next page.
H L
L H
15
15-9