YASKAWA E-7S SERVOPACK SGD7S Product Manual page 644

 ACC: Acceleration
Note: Refer to the following section for details on the acceleration rate.
13.3.5 Settings in the Program Table on page 13-13
 DEC: Deceleration
Note: Refer to the following section for details on the deceleration rate.
13.3.5 Settings in the Program Table on page 13-13
 POUT: Programmable Output Signals
Note: Refer to the following section for details on the programmable output signals.
13.3.5 Settings in the Program Table on page 13-13
 EVENT: Pass Condition
Change pass
condition
Change pass
condition
Change pass
condition
Change pass
condition
Change pass
condition
Change pass
condition
Change pass condition
Note: Refer to the following section for details on the pass condition and elapsed time.
13.3.5 Settings in the Program Table on page 13-13
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
17.2 Operation of Digital Operator
17.2.2 Operation of Utility Functions
Change acceleration
If the value becomes less than 1,
":" is displayed.
Change deceleration
If the value becomes less than 1,
":" is displayed.
Change programmable output signal
Pressing the key changes the display
in the following order.
N → A → Z → :
Pressing the key changes the display
in the reverse order.
Change elapsed time
Change elapsed time
Change elapsed time
Change elapsed time
Change elapsed time
Change elapsed time
Change elapsed time
17
17-15