YASKAWA E-7S SERVOPACK SGD7S Product Manual page 646

ZONE Table Edit/Save (FnB04)
This function edits and saves ZONE tables. Saving a ZONE table to flash memory after editing
it ensures that the data will be retained even after the control power has been turned off.
 Codes Displayed on the ZONE Table Editing Screen
For details on how to read the screen, refer to Reading the Screen on page 17-9.
ZONE
ZONE P
Number
0 ZP000
1 ZP001
31 ZP031
 Preparation
The following conditions must be met to edit and save ZONE tables.
• The write-prohibited setting (Fn010) must not be set to write-protect parameters.
• A ZONE table save operation must not be in progress for any means other than the digital
operator.
 Editing ZONE Tables
The operating procedure when setting ZONE N in ZONE number 5 is explained here.
Step Display after Operation
1
2
3
4
5
6
Repeat steps 3 to 6 to set the ZONE table. On completing the setting of all the ZONE tables to be
7 used, save the ZONE tables to flash memory by following the procedure in
page 17-18.
*
If setting is attempted in an operation prohibited state, it will not be possible to change the setting. In this case,
make the setting again by referring to
ZONE N
ZN000
ZN001
ZN031
Keys

Preparation on page 17-17.
17.2 Operation of Digital Operator
17.2.2 Operation of Utility Functions
Operation
Press the key to open the Utility Function
Mode main menu, and move the cursor with the
keys to select FnB04.
Press the key to view the FnB04 operation
screen.
Move the cursor using the
keys to select the ZONE table number to
be edited. Refer to the following section for details
on the methods to move the cursor.

Method for Moving the Cursor on page 17-13
Press the key to move the cursor to the set-
ting side of the table.
Move the cursor using the
change the ZONE boundary values using the
keys.*
On pressing the key, the setting is entered
and the cursor returns to the ZONE table number
side.

Saving ZONE Tables on
keys and
keys and
17
17-17