YASKAWA E-7S SERVOPACK SGD7S Product Manual page 651

17.2 Operation of Digital Operator
17.2.2 Operation of Utility Functions
ZONE Table Initialization (FnB07)
This function initializes ZONE tables and restores the settings on shipment from the factory.
 Preparation
The following conditions must be met to initialize ZONE tables.
• The write-prohibited setting (Fn010) must not be set to write-protect parameters.
• A ZONE table save operation must not be in progress for any means other than the digital
operator.
• Execution of the RES command must not be in progress.
 Operating Procedure
Step
1
2
3
4
5
*
If the
display returns to the FnB07 operation screen. In this case, make the setting again by referring to
17-22.
17-22
Display after Operation
key is pressed in an operation prohibited state, "Error." is displayed for approximately 2 seconds and then the
Keys
Press the
Mode main menu, and move the cursor with the
keys to select FnB07.
Press the
screen.
Press the
tion.*
Do not turn off the control power supply until ini-
tialization has been completed normally.
To cancel the FnB07 operation, press the
key before pressing the
returns to the Utility Function Mode main menu
without executing the operation.
When ZONE table initialization has been com-
–
pleted normally, "Done." is displayed.
Press the
Mode main menu.
Operation
key to open the Utility Function
key to view the FnB07 operation
key to start ZONE table initializa-
key. The display
key to return to the Utility Function

Preparation on page