YASKAWA E-7S SERVOPACK SGD7S Product Manual page 469

13.5 ZONE Outputs
13.5.3 SigmaWin+ Procedures
Saving the ZONE Table
 Saving the ZONE Table to Flash Memory in the SERVOPACK
To prevent the ZONE table from being deleted when the power supply to the SERVOPACK is
turned OFF, you must save it to flash memory in the SERVOPACK. The ZONE table that is
saved in the flash memory is automatically loaded each time the power supply is turned ON.
There are the following three ways to save the ZONE table to flash memory in the SERVO-
PACK.
• Save it on the Zone Table Editing.
• Save it with the ZONESTORE serial command.
• Save it with FnB04 (Edit/Save ZONE Table) on a Digital Operator.
Use the following procedure to save the ZONE table from the Zone Table Editing.
1.
Click the Save Button on the Zone Table Editing.
The Save Table Dialog Box will be displayed.
2.
Click the OK Button.
This concludes the saving procedure.
13-58