YASKAWA E-7S SERVOPACK SGD7S Product Manual page 643

17.2 Operation of Digital Operator
17.2.2 Operation of Utility Functions
 Details on How to Set Table Settings
Details on the setting method for step 5 in Editing Program Table on page 17-12 are shown
below.
If the number of display digits is exceeded when Expansion Mode is enabled (PnB54 = 1), the
table name will be abbreviated. Refer to the following section for details.
12.4.6 Digital Operator Displays on page 12-12
 POS: Target Position
Note: Refer to the following section for details on positioning types and target positions.
 SPD: Positioning Speed
Note: Refer to the following section for details on the positioning speed.
 RDST: Registration Distance
Note: Refer to the following section for details on the registration distance.
 RSPD: Registration Speed
Note: Refer to the following section for details on the registration speed.
17-14
Change positioning
type
Change positioning
type
Change positioning
type
Change positioning
type
Change positioning
type
Change positioning
type
13.3.5 Settings in the Program Table on page 13-13
13.3.5 Settings in the Program Table on page 13-13
13.3.5 Settings in the Program Table on page 13-13
13.3.5 Settings in the Program Table on page 13-13
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Move cursor
Change target position
Change target position
Change target position
Change positioning speed
Change registration distance
If the value becomes less than 0,
"−" is displayed.
Change registration speed