YASKAWA E-7S SERVOPACK SGD7S Product Manual page 645

17.2 Operation of Digital Operator
17.2.2 Operation of Utility Functions
 LOOP: Number of Executions
Note: Refer to the following section for details on the number of executions.
 NEXT: PGMSTEP to be Executed Next
Note: Refer to the following section for details on the program step to execute next.
 Saving Program Tables
The operating procedure for saving program tables is shown below.
Step
1
2
3
4
5
6
*
If the
display returns to the program table editing screen. In this case, make the setting again by referring to
page 17-11.
17-16
13.3.5 Settings in the Program Table on page 13-13
13.3.5 Settings in the Program Table on page 13-13
Display after Operation
key is pressed in an operation prohibited state, "Error." is displayed for approximately 2 seconds and then the
Move cursor
Move cursor
Keys
– Display the program table editing screen.
Press the
save operation screen.
Move the cursor with the
"STORE".
Note: Selecting "CANCEL" and pressing the
will return the display to the program table editing
screen.
Press the
table to flash memory.*
Do not turn off the control power supply until
saving has been completed normally.
When saving to flash memory has been com-
– pleted normally, the display returns to the pro-
gram table editing screen.
Press the
Mode main menu.
Change number of executions
Change next PGMSTEP to be executed
If the value becomes less than 0,
"END" is displayed.
Operation
key to view the program table
keys to select
key to start saving the program
key to return to the Utility Function

Preparation on
key