YASKAWA E-7S SERVOPACK SGD7S Product Manual page 598

Parameter
Name
No.
Application Function
2
Selections A
Motor Stopping Method for Group 2 Alarms

n. X
Pn00A
 
n. X Reserved parameter (Do not change.)
 
n. X Reserved parameter (Do not change.)

n.X Reserved parameter (Do not change.)
Application Function
2
Selections B
Operator Parameter Display Selection

n. X
Motor Stopping Method for Group 2 Alarms
 
n. X
Pn00B
Power Input Selection for Three-phase SERVOPACK
 
n. X

n.X Reserved parameter (Do not change.)
Setting Setting
Range Unit
0000h to
–
1044h
Apply the dynamic brake or coast the motor to a stop (use the
0
stopping method set in Pn001 = n.X).
Decelerate the motor to a stop using the torque set in Pn406 as
1 the maximum torque. Use the setting of Pn001 = n.X for the
status after stopping.
Decelerate the motor to a stop using the torque set in Pn406 as
2
the maximum torque and then let the motor coast.
Decelerate the motor to a stop using the deceleration time set in
3 Pn30A. Use the setting of Pn001 = n.X for the status after
stopping.
Decelerate the motor to a stop using the deceleration time set in
4
Pn30A and then let the motor coast.
0000h to
–
1121h
0 Display only setup parameters.
1 Display all parameters.
0 Stop the motor by setting the speed reference to 0.
Apply the dynamic brake or coast the motor to a stop (use the
1
stopping method set in Pn001 = n.X).
2 Set the stopping method with Pn00A = n.X.
0 Use a three-phase power supply input.
Use a three-phase power supply input and as a single-phase
1
power supply input.
16.2 List of Parameters
16.2.2 List of Parameters
Continued from previous page.
Default Applicable When
Setting Motors Enabled
After
0001h All
restart
After
0000h All
restart
Continued on next page.
Classi- Refer-
fication ence
–
Setup
Reference
page 5-36
Setup –
Reference
page 5-3
Reference
page 5-36
Reference
page 5-13
16
16-9