YASKAWA E-7S SERVOPACK SGD7S Product Manual page 659

17.2 Operation of Digital Operator
17.2.2 Operation of Utility Functions
Step
6
*
If the
display returns to the FnB0C operation screen. In this case, make the setting again by referring to
INDEXER Alarm History Display (FnB0D)
This function displays the history of alarms that have occurred at the SERVOPACK and
INDEXER Module.
 Preparation
None
 Operating Procedure
Step
1
2
3
4
Information
17-30
Display after Operation
key is pressed in an operation prohibited state, "Error." is displayed for approximately 2 seconds and then the
Display after Operation
To clear the alarm history, execute the Reset INDEXER Alarm (FnB0C) utility function with
Mode set to ALM History (clear alarm history). The alarm history is not cleared when you
reset an alarm (Mode = ALM state) or when the control power supply to the SERVOPACK is
turned OFF. Refer to the following section for the procedure.
INDEXER Alarm Reset (FnB0C) on page 17-29
Keys
Press the
Mode main menu.
Keys
Press the
Mode main menu, and move the cursor with the
keys to select FnB0D.
Press the
If no alarms occur, "NONE" is displayed.
Use the
Press the
Mode main menu.
Continued from previous page.
Operation
key to return to the Utility Function

Preparation.
Operation
key to open the Utility Function
key to view the alarm history.
keys to scroll the alarm history.
key to return to the Utility Function