16.2
List of Parameters
16.2.1
Interpreting the Parameter Lists
The types of Servomotors to which the parameter applies.
All: The parameter is used for both Rotary Servomotors and Linear Servomotors.
Rotary: The parameter is used for only Rotary Servomotors.
Linear: The parameter is used for only Linear Servomotors.
Rotary Servomotor terms are used for parameters that are applicable
to all Servomotors. If you are using a Linear Servomotor, you need to
interpret the terms accordingly. Refer to the following section for
details.
Parameter
No.
2
Pn000
Differences in Terms for Rotary Servomotors and
Linear Servomotors on page xi
Setting
Name
0000h to
Basic Function Selections 0
If there are differences in the parameters for Rotary
Servomotor and Linear Servomotor, information is
provided for both.
Top row: For Rotary Servomotors
Bottom row: For Linear Servomotors
Rotation Direction Selection
Movement Direction Selection
Use CCW as the forward direction.
0
Use the direction in which the linear encoder counts up as the for-
n.
X
ward direction.
Use CW as the forward direction. (Reverse Rotation Mode)
1
Use the direction in which the linear encoder counts down as the
forward direction. (Reverse Movement Mode)
n.
X
Reserved parameter (Do not change.)
n.
X
Reserved parameter (Do not change.)
Rotary/Linear Servomotor Startup Selection When Encoder Is Not Connected Reference
When an encoder is not connected, start as SERVOPACK for
0
n.X
Rotary Servomotor.
When an encoder is not connected, start as SERVOPACK for Lin-
1
ear Servomotor.
Setting
Default
Range
Unit
Setting
–
0000h
10B1h
There are the following two classifications.
Setup
Tuning
Refer to the following section for details.
16.2 List of Parameters
16.2.1 Interpreting the Parameter Lists
Indicates when a change to the
parameter will be effective.
Applica-
When
Classi-
ble Motors
Enabled
fication
All
After restart
Setup
5.1.1 Parameter Classification
on page 5-3
Reference
page 5-15
page 5-14
Refer-
ence
–
16
16-3