Port Input Special Function Control Register - Renesas M32R/ECU Series User Manual

Mitsubishi 32-bit risc single-chip microcomputers
Table of Contents

Advertisement

8

8.3.5 Port Input Special Function Control Register

Port Input Special Function Control Register (PICNT)
b8
9
10
0
0
0
b
Bit Name
8–10
No function assigned. Fix to "0".
11
XSTAT
XIN oscillation status bit
12–13
No function assigned. Fix to "0".
14
PISEL
Port input data select bit
15
PIEN0
Port input enable bit
Note 1: Only writing "0" is effective. Writing "1" has no effect; the bit retains the value it had before the write.
(1) XSTAT (XIN oscillation status) bit (Bit 11)
1) Conditions under which XSTAT is set to "1"
XSTAT is set to "1" upon detecting that XIN oscillation has stopped. When XIN remains at the same level for
a predetermined time (3 BCLK periods up to 4 BCLK periods), XIN oscillation is assumed to have stopped.
When operating normally, XIN changes state (high or low) once every BCLK period.
2) Conditions under which XSTAT is cleared to "0"
XSTAT is cleared to "0" by a system reset or by writing "0". If XSTAT is cleared at the same time it is set in (1)
above, the former has priority. Writing "1" to XSTAT is ignored.
3) Method for using XSTAT to detect XIN oscillation stoppage
Because the M32R/ECU internally contains a PLL, the internal clock remains active even when XIN oscilla-
tion has stopped.
By reading XSTAT without clearing it never once after reset, it is possible to know whether XIN has ever
stopped since the reset signal was deasserted. Similarly, by reading XSTAT after clearing it by writing "0", it
is possible to know the current oscillating status of XIN. (However, there must be an interval of at least 5
BCLK periods (20 CPU clock periods) between read and write.)
INPUT/OUTPUT PORTS AND PIN FUNCTIONS
11
12
13
14
XSTAT
PISEL
0
0
0
0
8.3 Input/Output Port Related Registers
b15
PIEN0
0
Function
0: XIN oscillating
1: XIN inactive
0: Content of port output latch
1: Port pin level
0: Disable input
1: Enable input
8-21
<Address: H'0080 0745>
<After reset: H'00>
R
0
R(Note 1)
0
R
R
32180 Group User's Manual (Rev.1.0)
W
0
0
W
W

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents