Renesas M32R/ECU Series User Manual page 679

Mitsubishi 32-bit risc single-chip microcomputers
Table of Contents

Advertisement

16
16.1 Outline of the Wait Controller
The Wait Controller controls the number of wait states inserted in bus cycles when accessing an extended exter-
nal area. The Wait Controller is outlined in the table below.
Table 16.1.1 Outline of the Wait Controller
Item
Target space
Number of wait states that can be inserted
During external extension and processor modes, four chip select signals (CS0# to CS3#) are output, each corre-
sponding to one of the four extended external areas referred to as CS0 through CS3.
H'0000 0000
H'000F FFFF
H'0010 0000
H'001F FFFF
H'0020 0000
H'003F FFFF
H'0040 0000
H'005F FFFF
H'0060 0000
H'007F FFFF
Figure 16.1.1 CS0–CS3 Area Address Map
When accessing the extended external area, the Wait Controller controls the number of wait states inserted in bus
cycles based on the number of wait states set by software and those entered from the WAIT# pin.
The number of wait states that can be controlled in software is 0 to 7.
When the input signal on the WAIT# pin is sampled low in the last cycle of internal wait state, the wait state is
extended as long as the WAIT# input signal is held low. Then when the WAIT# input signal is released back high,
the wait state is terminated and the next new bus cycle is entered into.
Description
Control is applied to the following address spaces depending on operation mode:
Single-chip mode:
No target space (Settings of the Wait Controller have no effect)
External extension mode: CS0 area (1 Mbytes), CS1 area (2 Mbytes),
CS2 area (2 Mbytes), CS3 area (2 Mbytes)
Processor mode:
CS0 area (2 Mbytes), CS1 area (2 Mbytes),
CS2 area (2 Mbytes), CS3 area (2 Mbytes)
0–7 wait states set by software + any number of wait states set from the WAIT# pin * One wait state is equivalent to one BCLK cycle.
Internal ROM area
CS0 area
CS1 area
CS2 area
CS3 area
<External extension mode>
16.1 Outline of the Wait Controller
Non-CS0 area
(Internal ROM access area)
<Processor mode>
16-2
WAIT CONTROLLER
CS0 area
(2MB)
CS1 area
(2MB)
CS2 area
(2MB)
CS3 area
(2MB)
32180 Group User's Manual (Rev.1.0)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents