Renesas M32R/ECU Series User Manual page 161

6
H'0000 0000
H'0000 1000
H'0000 2000
H'000F D000
H'000F E000
H'000F F000
Notes: • If the same bank area is set in two or more Virtual Flash S Bank Registers (FESBANK0-FESBANK7) and each register's flash
emulation enable bit (MODENS) is set to 1, the bank is assigned the corresponding internal RAM area in order of priority:
FESBANK0 > FESBANK1 > FESBANK2 > FESBANK3 > FESBANK4 > FESBANK5 > FESBANK6 > FESBANK7.
• If any 4-Kbyte area (S bank) specified by the Virtual Flash S Bank Register is accessed, its corresponding internal RAM area
is accessed. During virtual flash emulation mode, RAM can be accessed for read and write from both the internal RAM area and
the flash emulation areas set in the internal flash memory.
Figure 6.6.2 Virtual Flash Emulation Area of the M32180F8
S bank
S bank 0
S bank 1
S bank 2
S bank 254
S bank 255
Note 1: Set the eight start address bits A12-A19 of each S bank of internal flash memory that is divided in 4-Kbyte units
in the Virtual Flash S Bank Register's S bank address (SBANKAD) bits.
Figure 6.6.3 Values Set in the M32180F8's Virtual Flash S Bank Register
<Internal flash>
S bank 0
(4 Kbytes)
S bank 1
(4 Kbytes)
S bank 2
(4 Kbytes)
S bank 253
(4 Kbytes)
S bank 254
(4 Kbytes)
S bank 255
(4 Kbytes)
Start address of S bank
in flash memory
H'0000 0000
(Note 1)
H'0000 1000
(Note 1)
H'0000 2000
(Note 1)
H'000F E000
(Note 1)
H'000F F000
(Note 1)
6.6 Virtual Flash Emulation Function
<Internal RAM>
4 Kbytes
4 Kbytes
4 Kbytes
4 Kbytes
4 Kbytes
4 Kbytes
4 Kbytes
4 Kbytes
Values set in S bank
address (SBANKAD) bits
H'00
H'01
H'02
H'FE
H'FF
6-32
INTERNAL MEMORY
H'0080 4000
H'0080 8000
H'0080 9000
H'0080 A000
H'0080 B000
H'0080 C000
H'0080 D000
H'0080 E000
H'0080 F000
32180 Group User's Manual (Rev.1.0)