Timeout (Ping Polling) - Allied Telesis x510-28GTX Command Reference Manual

P -P C
ING OLLING OMMANDS
( )
TIMEOUT PING POLLING

timeout (ping polling)

Overview This command specifies the time in seconds that the polling instance waits for a
response to a ping packet. You may find a higher time-out useful in networks
where ping packets have a low priority.
The no variant of this command resets the set time out to the default of one
second.
timeout <1-30>
Syntax
no timeout
Default The default is 1 second.
Mode Ping-Polling Configuration
Examples To specify the timeout as 5 seconds for ping-poll instance 43, use the commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
To reset the timeout to its default of 1 second for ping-poll instance 43, use the
commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
Related critical-interval
Commands
fail-count
normal-interval
ping-poll
sample-size
show ping-poll
up-count
C613-50170-01 Rev B
Parameter Description
<1-30> Length of time, in seconds, that the polling instance waits for a
response from the polled device.
configure terminal
ping-poll 43
configure terminal
ping-poll 43
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
timeout 5
no timeout
2800