Type Memory - Allied Telesis x510-28GTX Command Reference Manual

T C
RIGGER OMMANDS

TYPE MEMORY

type memory
Overview This command configures a trigger to activate based on RAM usage level. Selecting
the up option causes the trigger to activate when memory usage exceeds the
specified level. Selecting the down option causes the trigger to activate when
memory usage drops below the specified level. Selecting any causes the trigger to
activate in both situations. The default is any.
type memory <1-100> [up|down|any]
Syntax
Mode Trigger Configuration
To configure trigger 12 to be a memory trigger that activates when memory usage
Examples
exceeds 50% use the following commands:
awplus#
awplus(config)#
awplus(config-trigger)#
To configure trigger 40 to be a memory trigger that activates when memory usage
either rises above or drops below 65%, use the following commands:
awplus#
awplus(config)#
awplus(config-trigger)#
or
awplus#
awplus(config)#
awplus(config-trigger)#
Related show trigger
Commands
trigger
C613-50170-01 Rev B
Parameter Description
<1-100>
The percentage of memory usage at which to trigger.
up
Activate when memory usage exceeds the specified level.
down
Activate when memory usage drops below the specified level.
any
Activate when memory usage passes the specified level in either
direction.
configure terminal
trigger 12
configure terminal
trigger 40
configure terminal
trigger 40
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
type memory 50 up
type memory 65
type memory 65 any
2767