Type Interface - Allied Telesis x510-28GTX Command Reference Manual

T C
RIGGER OMMANDS

TYPE INTERFACE

type interface
Overview This command configures a trigger to activate based on the link status of an
interface. The trigger can be activated when the interface becomes operational by
using the up option, or when the interface closes by using the down option. The
trigger can also be configured to activate when either one of these events occurs
by using the any option.
type interface <interface> [up|down|any]
Syntax
Mode Trigger Configuration
To configure trigger 19 to be an interface trigger that activates when port1.0.2
Example
becomes operational, use the following commands:
awplus#
awplus(config)#
awplus(config-trigger)#
Related show trigger
Commands
trigger
C613-50170-01 Rev B
Parameter Description
<interface>
Interface name. This can be the name of a device port, an
eth-management port, or a VLAN.
up
Activate when interface becomes operational.
down
Activate when the interface closes.
any
Activate when any interface link status event occurs.
configure terminal
trigger 19
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
type interface port1.0.2 up
2766