Example For Configuring The Traceroute Test; Figure 6-8 Networking Diagram For Configuring The Traceroute Test - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
#
vlan batch 100
#
interface Vlanif100
ip address 10.1.1.1 255.255.255.0
#
interface
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
nqa test-instance admin dns
test-type dns
destination-address url server.com
dns-server ipv4 10.3.1.1
#
ip route-static 10.3.1.0 255.255.255.0 10.1.1.2
#
return

6.37.6 Example for Configuring the Traceroute Test

Networking Requirements
As shown in
The traceroute test is used to check the IP address of the VLANIF 110 interface of Switch C on
Switch A.

Figure 6-8 Networking diagram for configuring the traceroute test

SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Create an NQA traceroute test on Switch A and set the destination IP address to 10.2.1.2.
Issue 03 (2010-09-20)
GigabitEthernet1/0/0
Figure 6-8:
GE1/0/0 GE1/0/0
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch A as the NQA client.
Create and perform the traceroute test on Switch A to check the statistics on each hop from
Switch A to Switch C.
Destination address for the traceroute test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE2/0/0
VLANIF110 VLANIF110
10.2.1.1/24 10.2.1.2/24
6 NQA Configuration
SwitchC
GE1/0/0
6-151