Configuring The Multicast Mode - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
----End

3.3.6 Configuring the Multicast Mode

This part describes how to configure the NTP multicast mode to synchronize clocks in a multicast
domain.
Procedure
l
l
Issue 03 (2010-09-20)
The local switch is configured as an NTP broadcast client.
Step 2 is optional. By default, a maximum of 100 NTP sessions can be set up
dynamically.
After the configurations, the local switch senses the broadcast NTP packets sent from
the server and synchronizes the local clock.
Running the ntp-service max-dynamic-sessions command does not affect the
existence of NTP sessions. When the number of the sessions reaches or exceeds the
maximum, the new session cannot be set up further.
Configuring an NTP Multicast Server
Do as follows on the switch functioning as an NTP multicast server:
1. Run:
system-view
The system view is displayed.
2. Run:
vlan vlan-id
A VLAN is created and the VLAN view is displayed.
3. Run:
interface vlanif vlan-id
The interface that sends NTP multicast packets is specified.
4. Run:
ntp-service multicast-server [ ip-address ] [ authentication-keyid key-id
| ttl ttl-number | version number ] *
The local switch is set to be an NTP multicast server.
After the configurations, the local switch periodically sends clock synchronization
packets to the multicast address 224.0.1.1.
Configuring an NTP Multicast Client
Do as follows on the switch functioning as an NTP multicast client:
1. Run:
system-view
The system view is displayed.
2. (Optional) Run:
ntp-service max-dynamic-sessions number
The number of local sessions allowed to be set up dynamically is set.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 NTP Configuration
3-11