Configuring The Jitter Test - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Context
Procedure
l
l
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
<Quidway> display nqa results
NQA entry(admin, udp) :testflag is inactive ,testtype is udp
1 . Test 1 result
Run the display nqa-server command. If the status of the NQA server is displayed, it means
that the configuration succeeds.
<Quidway> display nqa-server
NQA Server Max: 5000
NQA Concurrent TCP Server : 0
nqa-server udpecho 10.112.58.3 3000 ACTIVE

6.14 Configuring the Jitter Test

This section describes how to configure a jitter test to check jitter on the network. You can
perform a jitter test only when both the client and the server are Huawei devices.
6.14.1 Establishing the Configuration Task
Before configuring a jitter test, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
6.14.2 Configuring the Jitter Server
The IP address and number of the port monitored by the server must be identical with those
configured on the client.
6.14.3 Configuring the Jitter Client
This part describes how to configure the client of the jitter test.
Issue 03 (2010-09-20)
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
Run the display nqa results [ test-instance admin-name test-name ] command to view the
test results on the NQA client.
Run the display nqa-server command to view the information about the NQA server.
The test is finished
Send operation times: 3
Completion:success
Attempts number:0
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:10.2.1.2
Min/Max/Average Completion Time: 32/109/67
Sum/Square-Sum Completion Time: 203/16749
Last Good Probe Time: 2006-8-5 16:9:21.6
Lost packet ratio: 0 %
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
NQA Server Num: 1
NQA Concurrent UDP Server: 1
6 NQA Configuration
6-37