Configuring The Jitter Server; Configuring The Jitter Client - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
No.
4
5

6.14.2 Configuring the Jitter Server

The IP address and number of the port monitored by the server must be identical with those
configured on the client.
Context
Do as follows on the NQA server (Jitter server):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa-server udpecho [ vpn-instance vpn-instance-name ] ip-address port-number
The UDP monitoring service is configured.
Note that the IP address and port number monitored by the Jitter server should be consistent
with those configured on the client.
----End

6.14.3 Configuring the Jitter Client

This part describes how to configure the client of the jitter test.
Context
Do as follows on the NQA client (Jitter client):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Issue 03 (2010-09-20)
Data
(Optional) VPN instance name, source IP address and port number of the probe packet
sent by the UDP client, number of probe packets and test packets sent each time,
interval for sending probe packets and test packets, percentage of the failed NQA
tests, and version number carried in the Jitter packet
Start mode and end mode of the test
NOTE
The system supports the collection of the statistics about the maximum uni-directional transmission delay.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-39