Setting Parameters For The Mac Ping Test - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
No.
1
2
3
4

6.15.2 Setting Parameters for the MAC Ping Test

Context
Do as follows on the NQA client.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
cfm enable
The CFM is enabled globally.
Step 3 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 4 Run:
test-type macping
The test type is set to MAC Ping.
Step 5 Run:
destination-address mac mac-address
The destination MAC address of the MAC ping test is configured.
Step 6 Run:
md md-name ma ma-name
The MD and the MA are specified.
Step 7 (Optional) Run the following commands to set other parameters for the MAC Ping test.
l Run:
l Run:
Issue 03 (2010-09-20)
Data
Manager and name of the NQA test instance
Destination MAC address of the NQA test instance
Maintenance domain (MD) and maintenance association (MA) of the NQA test
instance
Starting and ending modes of the NQA test instance
interval seconds interval
The interval for sending test packets is set.
fail-percent percent
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-43