Huawei Quidway S9300 Configuration Manual - Network Management page 509

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
l
l
Issue 03 (2010-09-20)
If you change the ID of the management VLAN or delete the management VLAN and
its corresponding VLANIF interface on the administrator switch, the cluster is
automatically deleted.
If you change the ID of the management VLAN or delete the management VLAN and
its corresponding VLANIF interface on a member switch, the member switch
automatically quits the cluster.
Enabling the cluster function
Do as follows on the administrator switch and member switches:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster enable
The cluster function is enabled.
By default, the cluster function is not enabled on the device.
Creating a cluster
A cluster can be created manually or automatically on the S9300.
NOTE
If the administrator switch is rebooted after the HGMP cluster is created, member switches need to
be re-added into the cluster. In such a situation, numbering of these member switches may be changed.
Creating a cluster manually
These steps need to be configured only on the administrator switch or on the switch which
will be the administrator in a created HGMP cluster.
In this mode, you need to manually add member switches to the cluster.
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
The cluster view is displayed.
3. Run:
ip-pool administrator-ip-address { mask-length | mask }
The range of private IP addresses used in a cluster is set.
This command can be run only before the cluster is set up. If the cluster is set up, you
are not allowed to change the range of private IP addresses used in the cluster.
4. Run:
build cluster-name
Names of the administrator switch and the cluster are configured and the cluster is
created.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 HGMP Configuration
8-13