Huawei Quidway S9300 Configuration Manual - Network Management page 360

6 NQA Configuration
6.37.10 Example for Configuring the Jitter Test
6.37.11 Example for Configuring the MAC Ping Test
6.37.12 Example for Configuring the LSP Ping Test for a Common Tunnel
6.37.13 Example for Configuring the LSP Jitter Test for a Common Tunnel
6.37.14 Example for Configuring the LSP Jitter Test for the MPLS TE Tunnel
This part provides examples for configuring an LSP jitter test to measure jitter in the TE LSP
during the packet transmission.
6.37.15 Example for Configuring the LSP Traceroute Test for the TE Tunnel
6.37.16 Example for Configuring an ICMP Jitter Test
This part provides examples for configuring an ICMP jitter test to measure jitter on the network.
A server is not required in an ICMP jitter test and the peer device in the test instance can be non-
Huawei devices.
6.37.17 Example for Configuring a Path Jitter Test
This part provides examples for configuring a path jitter test to measure jitter along the packet
transmission path.
6.37.18 Example for Checking the RPF Path from the Source to the switch Through the MTrace
Test
6.37.19 Example for Checking the Multicast Path from the Source to the switch Through the
MTrace Test
6.37.20 Example for Checking the RPF Path from the Source to Destination Host Through the
MTrace Test
6.37.21 Example for Checking the Multicast Path from the Source to Destination Host Through
the MTrace Test
6.37.22 Example for Configuring the PWE3 Ping Test on a Single-Hop PW
6.37.23 Example for Configuring the PWE3 Ping Test on a Multi-Hop PW
6.37.24 Example for Configuring the PWE3 Trace Test on a Single-Hop PW
6.37.25 Example for Configuring the PWE3 Trace Test on a Multi-Hop PW
6.37.26 Example for Configuring an NQA Test Group
6.37.27 Example for Configuring the Test of Sending NQA Threshold Traps to the NMS
6.37.28 Example for Configuring Test Results to Be Sent to the FTP Server
This part provides examples for sending send test results to the FTP server to save test results
to the most extent.
6.37.29 Example for Configuring a Threshold for the NQA Alarm
This part provides examples for configuring the actions that the system needs to perform in
response to the threshold exceeding, such as generating logs, generating traps, or generating logs
and traps.
6.37.30 Example for Configuring NQA Upper/Lower Alarm Threshold and Test Instance
Linkage
This part provides examples for configuring the association of NQA test instances to dynamically
monitor faults on the network.
6-140 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)