Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
l To configure the size (packet header excluded) of the Echo-Request packet, run the
l To configure the time-to-live (TTL) value, run the ttl number command.
l To configure the type of service (ToS) field in the IP packet header, run the tos value
l To configure padding characters, run the datafill fillstring command.
l To configure the interval for sending the test packets, run the interval seconds interval
l To configure the percentage of the failed NQA test, run the fail-percent percent command.
l To configure the NQA test packets to be sent without searching the routing table, run the
Step 6 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
----End

6.5.3 Checking the Configuration

After configuring the ICMP test, you can view the test result.
Prerequisite
The configurations of the ICMP Test function are complete.
6-10
source-address ipv4 ip-address equals the "-a" option in the ping command.
datasize size command.
datasize size equals the "-s" option in the ping command.
ttl number equals the "-h" option in the ping command.
command.
tos equals the "-tos" option in the ping command.
datafill equals the "-p" option in the ping command.
command.
interval seconds equals the "-m" option in the ping command.
sendpacket passroute command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)