Figure 3-5 Networking Diagram For Configuring The Ntp Multicast Mode - Huawei Quidway S9300 Configuration Manual - Network Management

3 NTP Configuration
l

Figure 3-5 Networking diagram for configuring the NTP multicast mode

SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure the IP addresses of the Switches and ensure that the routes between them are
reachable.The configuration procedure is not mentioned.
Step 2 Configure the IP addresses of the Switches.
Configure the IP address of each interface according to
# Configure the IP address of the VLANIF interface on Switch C.
<SwitchC> system-view
[SwitchC] vlan 10
[SwitchC-Vlan10] quit
[SwitchC] interface gigabitethernet 1/0/0
[SwitchC-GigabitEthernet1/0/0] port hybrid pvid vlan 10
[SwitchC-GigabitEthernet1/0/0] port hybrid untagged vlan 10
[SwitchC-GigabitEthernet1/0/0] quit
[SwitchC] interface vlanif 10
[SwitchC-Vlanif10]ip address 3.0.1.31 24
[SwitchC-Vlanif10]quit
# Configure the IP address of the VLANIF interface on Switch D.
3-34
Switch A uses VLANIF 20, namely, GE1/0/0, to listen to the multicast packets.
GE1/0/0 GE1/0/0
VLANIF20 VLANIF20
1.0.1.11/24
1.0.1.2/24
Configure Switch C as the NTP multicast server.
Configure Switch A and Switch D as the NTP multicast clients.
IP address of each interface
Stratum count of the NTP master clock
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
3.0.1.31/24
GE2/0/0
VLANIF10
3.0.1.2/24
SwitchF
VLANIF10
3.0.1.32/24
Figure
GE1/0/0
VLANIF10
SwitchC
GE1/0/0
SwitchD
3-5.
Issue 03 (2010-09-20)