Example For Configuring The Lsp Ping Test For A Common Tunnel; Figure 6-14 Networking Diagram For Configuring The Lsp Ping Test - Huawei Quidway S9300 Configuration Manual - Network Management

Terabit routing switch

Hide thumbs Also See for Quidway S9300:

Table of Contents

Quidway S9300 Terabit Routing Switch

Configuration Guide - Network Management

6.37.12 Example for Configuring the LSP Ping Test for a Common

Networking Requirements

The NQA LSP Ping test needs to be performed to check the connectivity of the LSP between

Switch A and Switch C.

Configuration Roadmap

The configuration roadmap is as follows:

Data Preparation

To complete the configuration, you need the following data:

Issue 03 (2010-09-20)

The OSPF protocol runs on Switch A, Switch B, and Switch C. The three Switches learn

the 32-bit host routes on their loopback interfaces.

MPLS and MPLS LDP are enabled on Switch A, Switch B, and Switch C.

MPLS and MPLS LDP are enabled on VLANIF interfaces connected to Switch A,

Switch B, and Switch C to trigger the establishment of an LDP LSP.

Configure Switch A as the NQA client.

Configure Switch C as the NQA server.

Create an LSP Ping test on Switch A.

Host address and mask of the NQA server

Huawei Proprietary and Confidential

6 NQA Configuration