Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
l Run:
l Run:
l Run:
Step 6 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
----End

6.20.3 Checking the Configuration

After configuring the path jitter test, you can view the test result.
Prerequisite
The configurations of the Path Jitter Test function are complete.
6-70
jitter-packetnum number
The number of test packets to be sent during each test is set.
NOTE
The probe-count command is used to configure the number of times for the jitter test and the jitter-
packetnum command is used to configure the number of test packets sent during each test. In actual
configuration, the product of the number of times for the jitter test and the number of test packets must
be less than 3000.
interval seconds interval
The interval for sending jitter test packets is set.
The shorter the interval is, the sooner the test is complete. However, delays arise when the
processor sends and receives test packets. Therefore, if the interval for sending test packets
is set to a small value, a relatively greater error may occur in the statistics of the jitter test.
fail-percent percent
The percentage of the failed NQA tests is set.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
NOTE
NQA test results cannot be displayed automatically on the terminal. You should run the display nqa
results command to check the test results.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)