Figure 6-26 Networking Diagram For Configuring The Pwe3 Trace Test On A Single-Hop Pw - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
The PWE3 Trace function of the single-hop PW needs to be performed to test the connectivity
of the PW between PE-A and PE-B.

Figure 6-26 Networking diagram for configuring the PWE3 Trace test on a single-hop PW

Loopback0
192.2.2.2/32
PE-A
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Configure a dynamic single-hop PW.
Configure a dynamic single-hop PW on the MPLS backbone network.
For the detailed configuration procedure, see "PWE3 Configuration" in the Quidway S9300
Terabit Routing Switch Configuration Guide - VPN.
Issue 03 (2010-09-20)
GE2/0/0
GE1/0/0
VLANIF120
10.1.1.1/24
VLANIF120
GE1/0/0
VLANIF110
10.1.1.2/24
GE1/0/0
VLANIF10
100.1.1.1/24
CE-A
Run the IGP protocol on the backbone network to make the routes between Switches on
the backbone network reachable.
Configure the basic MPLS functions on the backbone network and set up an LSP tunnel.
Set up the MPLS LDP peer relation between the two PE devices on the two ends of the
PW.
Create an MPLS L2VC connection between the two PE devices.
Configure a PWE3 Trace test on a single-hop PW on PE-A.
L2VC IDs of the two ends of the PW, which must be the same
MPLS LSR-IDs of the PE and P devices
IP address of the remote peer
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MPLS Backbone
Loopback0
192.4.4.4/32
GE2/0/0
VLANIF130
10.2.2.1/24
P
PW
6 NQA Configuration
Loopback0
192.3.3.3/32
GE2/0/0
VLANIF130
10.2.2.2/24
GE1/0/0
VLANIF140
PE-B
GE1/0/0
VLANIF140
CE-B
100.1.1.2/24
6-215