Huawei Quidway S9300 Configuration Manual - Network Management page 459
Terabit routing switch
Hide thumbs
Also See for Quidway S9300:
- Configuration manual (603 pages) ,
- Configuration manual - multicast (262 pages) ,
- Hardware description (224 pages)
Table of Contents
Advertisement
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Enable the NQA client and create an NQA ICMP test instance.
<SwitchA> system-view
[SwitchA] nqa test-instance admin icmp
[SwitchA-nqa-admin-icmp] test-type icmp
[SwitchA-nqa-admin-icmp] destination-address ipv4 11.1.1.2
[SwitchA-nqa-admin-icmp] quit
Step 2 On Router A, configure the event that triggers test instance linkage and create a linked test
instance admin icmp.
[SwitchA] nqa event 10 linkage admin icmp
Step 3 On Router A, create an NQA ICMP Jitter test instance.
[SwitchA] nqa test-instance admin icmpjitter
[SwitchA-nqa-admin-icmpjitter] test-type icmpjitter
[SwitchA-nqa-admin-icmpjitter] destination-address ipv4 11.1.1.2
# Configure the alarm threshold.
[SwitchA-nqa-admin-icmpjitter] alarm 10 lost-packet-ratio absolute rising-
threshold 80 10 falling-threshold 10 10
Step 4 Start the test.
[SwitchA-nqa-admin-icmpjitter] start now
Step 5 Verify the configuration.
# Check information about the event that triggers test instance linkage.
<SwitchA> display nqa event
NQA Event Information:
--------------------------------------------------------------------------------
Event-Entry
--------------------------------------------------------------------------------
10
# Check alarm information about all test instances.
Issue 03 (2010-09-20)
Configure Switch A as the NQA client and Switch B as the NQA server.
On the NQA client, configure the type of the linking test instance to be ICMP.
On the NQA client, specify the event that triggers test instance linkage.
On the NQA client, create an ICMP Jitter test instance, as a primary test instance.
On the NQA client, configure the alarm threshold.
On the NQA client, start the primary test instance.
Index of the linking test instance
Number of the event associated with the threshold
Number of the alarm threshold
Upper threshold and lower threshold
Event-type
linkage
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Admin-Name
admin
6 NQA Configuration
Operation-Tag
icmp
6-239
Advertisement
Table of Contents
