Huawei Quidway S9300 Configuration Manual - Network Management page 522

8 HGMP Configuration
l
l
8-26
cluster-plug-play ip ftp-ip-address username user-name password password
[ path-separator pathseparator ]
The default information for logging in to the FTP server is configured.
4. Run:
cluster-plug-play enable
The plug-and-play function is enabled.
– To configure the management VLAN for the interface of the administrator switch,
you should run the port trunk allow-pass vlan command rather than the port
default vlan command if the cluster-plug-play enable command needs to be used.
This interface is directly connected to the candidate switch.
– Step 3 is used in the scenario of replacing devices. The new device automatically
downloads the configuration files of the old device. Prerequisites for the operation
is that configuration files of the old device exist on the FTP server and the physical
topologies and types of the new device and old device are the same.
Configuring Communication Between Huawei Devices and Non-Huawei Devices
Do as follows on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
The cluster view is displayed.
3. Run:
cluster-packet-extend enable
Communication Between Huawei Devices and Non-Huawei Devices is enabled.
– To configure the management VLAN for the interface of the administrator switch,
you should run the port trunk allow-pass vlan command rather than the port
default vlan command if the cluster-packet-extend enable command needs to
be used. This interface is directly connected to the candidate switch.
Configuring the incremental configuration function
Do as follows on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
The cluster view is displayed.
3. Run:
increment
The incremental configuration view is displayed.
4. Run:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)