Huawei Quidway S9300 Configuration Manual - Network Management page 240

6 NQA Configuration
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test is created and the view is displayed.
Step 3 Run:
test-type http
The test type is set to HTTP.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other parameters for the HTTP test:
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the source port, run the source-port port-numbercommand.
l To configure the destination port, run the destination-port port-number command.
l To configure the percentage of the failed NQA HTTP tests, run the fail-percent percent
l To configure the NQA test packet to be sent without searching the routing table, run the
Step 6 Run:
http-operation { get | post }
The HTTP operation type is configured.
By default, the HTTP operation type is Get.
Step 7 Run:
http-url deststring [ verstring ]
The web page to be visited and the HTTP version are configured.
Step 8 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
6-20
command.
command.
sendpacket passroute command.
NOTE
Run the http-url deststring [ verstring ] command and enter the name of the web page directly. If the input
content contains http:// and the domain name, the test may fail.
When information on the HTTP version is not configured, by default, HTTP1.0 is supported. HTTP1.1 can
be supported through your configurations.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)