Configuring The Lsp Ping Test; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management

6.16 Configuring the LSP Ping Test

This section describes how to configure a Label Switched Path (LSP) ping test to check the
operating status of the LSP.

6.16.1 Establishing the Configuration Task

Before configuring an LSP ping test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
6.16.2 Configuring the LSP Ping Test Parameters for the LDP Tunnel
Before performing an LDP LSP ping test, you need set parameters for the LSP ping test.
6.16.3 Configuring the LSP Ping Test Parameters for the MPLS TE Tunnel
Before performing the TE LSP ping test, you need set parameters for a TE LSP ping test.
6.16.4 Configuring the LSP Ping Test Parameters for the CR-LSP Hotstandby Tunnel
Before performing the LSP ping test, you need set LSP ping test parameters for CR-LSP tunnels
in hot standby mode.
6.16.5 Checking the Configuration
After configuring the LSP ping test, you can view the test result.
6.16.1 Establishing the Configuration Task
Before configuring an LSP ping test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
The NQA LSP Ping test can be used to test the reachability of the following types of Label
Switched Paths (LSPs) and collect statistics about Link State Advertisement (LSA).
l
l
l
After the test parameters are configured and the test is started,
Issue 03 (2010-09-20)
Max Negative SD:0
Negative SD Number:0
Negative SD Sum:0
Negative SD Square Sum :0
Min Delay SD:0
Avg Delay SD:0
Max Delay SD:0
Packet Loss SD:0
Packet Loss Unknown:0
Average of Jitter SD:0
jitter out value:0.0000000
NumberOfOWD:0
OWD DS Sum:0
Packet Loss Ratio: 0
ICPIF value:0
LSP tunnels
MPLS TE tunnels
MPLS CR-LSP hotstandby tunnels
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Max Negative DS:0
Negative DS Number:0
Negative DS Sum:0
Negative DS Square Sum :0
Min Delay DS:0
Avg Delay DS:0
Max Delay DS:0
Packet Loss DS:0
Average of Jitter:0
Average of Jitter DS:0
jitter in value:0.0000000
OWD SD Sum:0
RTT average: 0
MOS-CQ value:0.00
6 NQA Configuration
6-45