Configuring Ntdp - Huawei Quidway S9300 Configuration Manual - Network Management

8 HGMP Configuration
l
l
----End

8.2.3 Configuring NTDP

This section describes how to configure the Network Topology Discovery Protocol (NTDP) to
collect information about network topologies.
Procedure
l
8-10
– Run:
interface interface-type interface-number
The interface view is displayed.
Run:
ndp enable
NDP is enabled on the interface.
(Optional) Setting the aging time of NDP packets
Do as follows on the administrator switch and member switches:
1. Run:
system-view
The system view is displayed.
2. Run:
ndp timer aging aging-time
The aging time of NDP packets is set.
By default, the aging time of NDP packets is set to 180 seconds. The aging time of
NDP packets must be longer than the interval for sending NDP packets.
(Optional) Setting the interval for sending NDP packets
Do as follows on the administrator switch and member switches:
1. Run:
system-view
The system view is displayed.
2. Run:
ndp timer hello interval
The interval for sending NDP packets is set.
By default, the interval for sending NDP packets is set to 60 seconds. The interval for
sending NDP packets must be shorter than the aging time of NDP packets.
Enabling NTDP in the system view
1. Run:
system-view
The system view is displayed.
2. Run:
ntdp enable
NTDP is enabled in the system view.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)