Configuration Examples; Example For Configuring Static Lsps - Huawei AR1200 Series Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - MPLS
Context
Run the following commands in the system view to notify the Network Management System
(NMS) of LSP status changes.
By default, the trap function is disabled during the setup of the LDP LSP.
Procedure
l
----End

1.6 Configuration Examples

The following sections provide several examples of the static LSP configurations. Familiarize
yourself with the configuration procedures against the networking diagram. Each configuration
example consists of the networking requirements, configuration precautions, configuration
roadmap, configuration procedures, and configuration files.

1.6.1 Example for Configuring Static LSPs

This section provides an example for configuring a static LSP.
Networking Requirements
As shown in
backbone network.
Bidirectional static LSPs are set up between LSRA and LSRD. The LSP from LSRA to LSRD
is LSRA -> LSRB -> LSRD; the LSP from LSRD to LSRA is LSRD -> LSRC -> LSRA.
Figure 1-1 Networking diagram of configuring static LSPs
L o o p b a ck1
1 .1 .1 .9 /3 2
Issue 01 (2012-04-20)
Run the snmp-agent trap suppress feature-name lsp trap-name { mplsxcup |
mplsxcdown } trap-interval trap-interval [ max-trap-number max-trap-number ]
command in the system view to enable the trap function for the LDP LSP and enable the
debugging of excessive mplsxcup or mplsxcdown information.
Figure 1-1, the LSRs support MPLS and OSPF as an IGP running on the MPLS
L S R A
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
L o o p b a ck1
2 .2 .2 .9 /3 2
L S R B
L S R C
L o o p b a ck1
3 .3 .3 .9 /3 2
1 Static LSPs Configuration
L o o p b a ck1
4 .4 .4 .9 /3 2
L S R D
13