Optional) Adjusting The Performance Of The Nqa Mtrace Test - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
mtrace-source-address ipv4 ip-address
The address of the multicast source is specified.
Step 4 Run:
mtrace-group-address ipv4 ip-address
The multicast group address is specified. Note that the address must be a common group address.
Step 5 (Optional)The VPN instance is specified.
vpn-instance vpn-instance-name
Step 6 Run:
quit
Exit from the test instance view.
----End
6.22.4 (Optional) Adjusting the Performance of the NQA MTrace
Test
This part describes how to set optional MTrace test parameters according to the network
operating status.
Context
Do as follows on the switch with the MTrace test being configured:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
Issue 03 (2010-09-20)
NOTE
The steps described in this procedure are all optional.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
6-79