Configuring The Ftp Upload Test Parameters - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
No.
3
4
5
6

6.7.2 Configuring the FTP Upload Test Parameters

This part describes how to set parameters for the FTP upload test.
Context
Do as follows on the NQA client (FTP client):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type ftp
The test type is set to FTP.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other parameters for the FTP upload
test:
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
l To configure the source port, run the source-port port-numbercommand.
l To configure the destination port, run the destination-port port-number command.
l To configure the NQA test packet to be sent without searching the routing table, run the
Step 6 Run:
ftp-operation put
6-16
Data
FTP user name and password
(Optional) Source IP address of the FTP operation and VPN instance name and source
and destination port numbers of the FTP operation
Name or size of the uploaded file
Start mode and end mode of the test
command.
sendpacket passroute command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)