Configuring Ndp - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Data Preparation
To configure basic HGMP functions, you need the following data.
No.
1
2
3
4
5
6

8.2.2 Configuring NDP

This part describes how to configure the Neighbor Discovery Protocol (NDP) to collect
information about directly connected neighbors.
Procedure
l
l
Issue 03 (2010-09-20)
Data
Range of private IP addresses used in the cluster
Cluster name
Medium access control (MAC) address of the member switch
(Optional) Aging time of NDP packets and interval for sending NDP packets
(Optional) Range of topology collection, hop delay and interface delay in forwarding
NTDP topology request packets, interval for topology collection
(Optional) ID of the management VLAN, aging time of NDP packets, interval for
sending handshake packets, address of the SNMP host, and IP addresses of the FTP
server and the SFTP server
Enabling NDP in the system view
Do as follows on the administrator switch and member switches:
1. Run:
system-view
The system view is displayed.
2. Run:
ndp enable
By default, NDP is not enabled in the system view.
Enabling NDP on an interface
Do as follows on the administrator switch and member switches:
1. Run:
system-view
The system view is displayed.
2. Run the following command as required:
– Run:
ndp enable interface { interface-type interface-number [ to interface-
type interface-number ] }&<1-10>
NDP on an interface is enabled in the system view.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 HGMP Configuration
8-9