Checking The Configuration - Huawei Quidway S9300 Configuration Manual - Network Management

Terabit routing switch
Hide thumbs Also See for Quidway S9300:
Table of Contents

Advertisement

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management

4.3.12 Checking the Configuration

Prerequisite
The configurations are complete.
Procedure
l
l
l
l
----End
Example
Run the display lldp local command. If the status of global LLDP is enabled, the status of LLDP
on interface is enabled, the LLDP management address is 10.10.10.1, the status of LLDP trap
is disabled, and the LLDP attributes are set correctly, it means that the configuration is successful.
LLDP attributes include the interval for sending LLDP packets, delay for sending LLDP packets,
time multiplier of device information held in neighbor stations, delay for re-enabling the LLDP
function on an interface, and delay for sending traps of neighbor changes are set correctly.
<Quidway> display lldp local
System information
Chassis type
Chassis ID
System name
System description
Huawei Versatile Routing Platform Software
VRP (R) Software, Version 5.70 (S9300 V100R003C00B042)
Copyright (c) 2003-2010 Huawei Technologies Co., Ltd
System capabilities supported
System capabilities enabled
LLDP Up time
MED system information
Device class
(MED inventory information of master board)
HardwareRev
FirmwareRev
SoftwareRev
SerialNum
Manufacturer name :NA
Model name
Asset tracking identifier :NA
System configuration
LLDP Status
LLDP Message Tx Interval
LLDP Message Tx Hold Multiplier :4
LLDP Refresh Delay
LLDP Tx Delay
LLDP Notification Interval
LLDP Notification Enable
Issue 03 (2010-09-20)
Run the display lldp local [ interface interface-type interface-number ] command to view
the LLDP status on the local device.
Run the display lldp neighbor [ interface interface-type interface-number ] command to
view the neighbor information about the interface.
Run the display lldp neighbor brief command to view the brief information about the
neighbors.
Run the display lldp tlv-config command to view the type of TLV that can be sent by an
interface.
:macAddress
:00e0-11fc-1710
:Quidway
:Quidway S9300
:2009/2/13 11:40:49
:Network Connectivity
:LE01MCUA VER.A
:NC
:Version 5.70 V100R003C00B042
:NA
:NA
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
:bridge
:bridge
:enabled
:30
:2
:2
:5
:disabled
4 LLDP Configuration
(default is disabled)
(default is 30s)
(default is 4)
(default is 2s)
(default is 2s)
(default is 5s)
(default is disabled)
4-13

Advertisement

Table of Contents
loading

Table of Contents