Figure 6-31 Networking Diagram Of Configuring A Threshold For The Nqa Alarm - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration

Figure 6-31 Networking diagram of configuring a threshold for the NQA alarm

VLANIF20
11.1.2.1/24
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure Switch A as the client of the ICMP jitter test. The configuration details are not
mentioned here.
Step 2 Configure the event corresponding to the alarm on Switch A.
<SwitchA> system-view
[SwitchA] nqa event 10 log-trap
Step 3 Configure the alarm threshold.
[SwitchA] nqa test-instance admin icmpjitter
[SwitchA-icmpjitter] test-type icmpjitter
[SwitchA-icmpjitter] destination-address ipv4 11.1.1.20
[SwitchA-icmpjitter] frequency 5
[SwitchA-icmpjitter] alarm 10 lost-packet-ratio absolute rising-threshold 100 10
falling-threshold 10 10
[SwitchA-icmpjitter] quit
Step 4 Configure alarms to be sent to the NM station.
# Configure basic SNMP functions.
6-236
NM Station
11.1.2.8/24
GE2/0/0
GE1/0/0
VLANIF10
11.1.1.1/24
Configure the event corresponding to the alarm threshold.
Configure the alarm threshold.
Configure alarms to be sent to the NM station.
Start the test instance.
Number of the event corresponding to the threshold
Number of the alarm threshold
Upper threshold and lower threshold
IP address of the NM station
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
GE1/0/0
SwitchB
VLANIF10
11.1.1.20/24
Issue 03 (2010-09-20)