Huawei Quidway S9300 Configuration Manual - Network Management page 376

6 NQA Configuration
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure the NQA server on Switch C.
# Configure the IP address and port number used to monitor TCP connections on the NQA server.
<SwitchC> system-view
[SwitchC] nqa-server tcpconnect 10.2.1.2 9000
Step 3 # Configure Switch A.
# Enable the NQA client and create a TCP Private test.
<SwitchA> system-view
[SwitchA] nqa test-instance admin tcp
[SwitchA-nqa-admin-tcp] test-type tcp
[SwitchA-nqa-admin-tcp] destination-address ipv4 10.2.1.2
[SwitchA-nqa-admin-tcp] destination-port 9000
Step 4 Perform the test.
[SwitchA-nqa-admin-tcp] start now
Step 5 Verify the test result.
[SwitchA-nqa-admin-tcp] display nqa results test-instance admin tcp
NQA entry(admin, tcp) :testFlag is inactive ,testtype is tcp
1 . Test 1 result
----End
Configuration Files
l
6-156
Configure Switch A as the NQA client and configure Switch C as the NQA server.
Configure the monitoring port number on the NQA server and create an NQA TCP test on
the NQA client.
Host address of the server
Port number used to monitor the TCP service on the server
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:10.2.1.2
Min/Max/Average Completion Time: 46/63/52
Sum/Square-Sum Completion Time: 156/8294
Last Good Probe Time: 2006-8-5 15:53:17.8
Lost packet ratio: 0 %
Configuration file of Switch A
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
Issue 03 (2010-09-20)