Creating An Nqa Mtrace Test; Configuring The Nqa Mtrace Test - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration
No.
1
2
3
4

6.22.2 Creating an NQA MTrace Test

This part describes how to configure an MTrace instance before performing the MTrace test for
the multicast path from the multicast source to the querier.
Context
Do as follows on the switch that functions as the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type mtrace
The test type is set to MTrace.
Step 4 Run:
quit
Exit from the test instance view.
----End

6.22.3 Configuring the NQA MTrace Test

This part describes how to set parameters for the MTrace test for the multicast path from the
multicast source to the querier.
Context
Do as follows on the switch with the NQA MTrace test instance being created:
6-78
Data
Name of the test instance
IP address of the multicast source
Multicast group address
VPN instance
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
Issue 03 (2010-09-20)