Configuring The Lsp Traceroute Test; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual - Network Management

Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
<Quidway> display nqa results
NQA entry(admin, lspjitter) :testflag is inactive ,testtype is lspjitter
1 . Test 1 result
SendProbe:60
Completion:success
Min/Max/Avg/Sum RTT:1/24/3/156
NumOfRTT:60
Operation sequence errors number:0
System busy operation number:0
Min Positive SD:1
Positive SD Number:12
Positive SD Square Sum:495
Max Negative SD:22
Negative SD Sum:34
Packet Loss Unknown:0
jitter out value:0.8977973

6.18 Configuring the LSP Traceroute Test

This section describes how to configure an LSP traceroute test to check the connectivity between
Label Switching Routers (LSRs) along the LSP.

6.18.1 Establishing the Configuration Task

Before configuring an LSP traceroute test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
6.18.2 Configuring the LSP Traceroute Parameters for the LDP Tunnel
This part describes how to set parameters for an LDP LSP traceroute test.
6.18.3 Configuring LSP Traceroute Test Parameters for the MPLS TE Tunnel
This part describes how to set parameters for a TE LSP traceroute test.
6.18.4 Configuring the LSP Traceroute Test Parameters for the CR-LSP Hotstandby Tunnel
This part describes how to set LSP traceroute test parameters for CR-LSP hot standby tunnels.
6.18.5 Checking the Configuration
After configuring the LSP traceroute test, you can view the test result.
6.18.1 Establishing the Configuration Task
Before configuring an LSP traceroute test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Issue 03 (2010-09-20)
– Number of successful tests
– Sum of the response time of all tests
– RTT square sum
– Minimum RTT and maximum RTT of the packet
– Destination IP address and the type of the destination IP address
– Number of the Echo packets and the sent packets
– Time when the last packet is received
The test is finished
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ResponseProbe:60
RTD OverThresholds number:0
RTT Square Sum:928
Drop operation number:0
RTT Stats errors number:0
Operation timeout number:0
Max Positive SD:22
Positive SD Sum:33
Min Negative SD:1
Negative SD Number:12
Negative SD Square Sum:498
Average of Jitter SD:2
Packet Loss Ratio: 0%
6 NQA Configuration
6-57