Example For Configuring The Jitter Test; Figure 6-12 Networking Diagram For Configuring The Jitter Test - Huawei Quidway S9300 Configuration Manual - Network Management

6 NQA Configuration

6.37.10 Example for Configuring the Jitter Test

Networking Requirements
As shown in
transmitting a packet from Switch A to Switch C. Switch A and Switch C synchronize the clock
from Switch B so that the test precision is improved.

Figure 6-12 Networking diagram for configuring the Jitter test

SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure the NQA server on Switch C.
# Configure the IP address and UDP port number monitored by the NQA server.
<SwitchC> system-view
[SwitchC] nqa-server udpecho 10.2.1.2 9000
Step 3 # Configure Switch A.
6-160
#
return
Figure 6-12, the NQA Jitter test needs to be used to obtain the jitter time of
NOTE
For information about clock synchronization, see "NTP" in the Quidway S9300 Terabit Routing Switch
Feature Description - Network Management.
GE1/0/0 GE1/0/0
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch C as the NTP client and configure Switch B as the NTP server.
Configure Switch A as the NQA client and configure Switch C as the NQA server.
Configure the service type and port number monitored by the NQA server.
Create and perform the NQA Jitter test on the NQA client.
Host address of the server
Port number used to monitor the UDP service on the server
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
SwitchB
GE2/0/0
VLANIF110
VLANIF110
10.2.1.1/24
10.2.1.2/24
SwitchC
GE1/0/0
NQA Server
Issue 03 (2010-09-20)